node-red-contrib-telldus-zwave-v2-local

Information

A Telldus contrib that adds three different nodes to your palette to either control or retreive information from your different z-wave devices, using the local API of Telldus z-wave v2. This package adds 3 nodes, a device node, a metric sensor node and a switch sensor node, together with a configuration node to share the configuration between all your nodes.

Compatibility

These nodes might work for other Telldus gateway devices, but that has not been confirmed.

Installation

Either search the palette in NodeRED, or use

npm install node-red-contrib-telldus-zwave-v2-local

Nodes

Device node

Control Telldus devices by sending payloads with commands. Supported commands as of now for the Device node are 'on', 'off', 'up', 'down', 'bell', 'stop' and 'dim(x)'.

Metric Sensor node

The metric sensor outputs metrics from you sensors or multi sensors. Such as temperature or uv. If using a multi sensor, you can filter what metrics you want to output.

Switch Sensor node

The switch sensor outputs the state of a on/off sensor. For example a window or door sensor. This node can also be setup to only output messages when the state change.

Configuration node

The nodes share a gateway configuration that needs to be configured before any of the nodes can be used. You can either use the built in access token wizard that automates the process of retreiving an access token, or you can follow the the instruction on this page to enter them manually: Get Access Token